Instructions

TYE MASTER™
Instruction Sheet

Assemble TYE MASTER™

Attach the two (2) fingers with the screws provided. Insert the screws from the back of the TYE MASTER™ through the pre-drilled holes and attach one (1) finger to each screw. Tighten screws as much as possible.

Attach TYE MASTER™ to Tank

Place the belt over the top of the tank and with the help of another person; have them firmly bend the TYE MASTER™ to the shape of the tank. When the TYE MASTER™ is held firmly to the side of the tank, tighten the belt. The TYE MASTER™ must be very tight on the tank. Make sure you place the TYE MASTER™ at a level where it is comfortable for you to work, approximately waist level.

Tying Balloons

	Hold inflated balloon firmly at the fat part of the balloon with one hand and stretch the neck of the balloon several times with your other hand.
	Place the fat part of the balloon as close as you can to the top finger. Do not place the balloon too far back on the top finger.
	Wrap the neck of the balloon all the way around both fingers and then through the middle.
	Grasp the end of the neck of the balloon and pull gently off the fingers.
	Tighten the knot of the balloon.
	View Video

Hints

	If you place the balloon too far back on the fingers you will find it is too hard to pull the balloon off.
	If you need to attach any ribbon or decorative items to the balloon, do so after you have wrapped the balloon all the way around the fingers pulling the end of the balloon straight up. The balloon will stay on the end of the fingers while you put whatever you need through the middle of the fingers, then grab the end of the balloon, pull it off the fingers and then tighten the knot.
	You may find it a little awkward at first, but practice by using it to tie your 11" balloons until you get the hang of it. After a little practice you will be tying to your hearts content.

Order TYE MASTER™

TYE MASTER™ Home

Send Email with questions or comments. Copyright © 1997-2006 Balloons To Go